Exterior kMeter Module: Quick Start Guide

An overview of how to quickly get up and running with the kMeter.  feedback system for the kBox. 1. Plug in the exterior kMeter Module. Turn the kBox upside down

An overview of how to quickly get up and running with the kMeter feedback system for the kBox.

1. Plug in the exterior kMeter Module

  • Turn the kBox upside down.
  • Locate the kMeter socket on the kBox, placed on the side of the vertical reinforcement plate (picture 1).
  • Plug the kMeter connector into the socket.

 

2. Attach the exterior kMeter Module (optional)

If desired, the kMeter Module can be attached to the kBox using the included velcro tape:

  • Place one piece of velcro tape on the kBox.
  • Place the corresponding piece on the kMeter. Do not cover the battery lid. (picture 3)
  • Attach the tape on the exterior kMeter Module to the tape on the kBox.

 

3. Get the free Exxentric App

 

4. Connect the App with the Module

  • Press the on/off button on the exterior kMeter Module (picture 2) until it starts blinking with a blue light. (It turns off automatically after a while, if not in use.)
  • Make sure that Bluetooth on your mobile device is turned on, then start the Exxentric app.
  • In the app, click the green Connect-button from the start screen. (Status will change from Not connected to Connected + serial number of your exterior kMeter Module.)
  • Go through the rest of the setup process in the app and click Close.

 

5. Ready!

  • Start playing and work hard. Happy DOMS!